On this post, we are going to share how to remove pin/ password/ pattern and Frp Lock of Diamond D100 Plus mobile. We use Infinity CM2 dongle to perform this task.
1) Open Infinity SPD Tool,
2) On Setting Select Cpu: SP [SC773x] eMMC [Android 6.x],
3) Go to Service and Click Read/ check info,
4) Power off phone Press volume + key as a boot key and insert usb cable,
5) If Read info done, you can easily format/ flash your phone,
6) Click on Format FS/ Reset Phone/ Clear FRP,
7) Wait until all process done.
Here is log:
Operation : Format File System / Reset Settings [ v1.25 ]
Settings : SmartFormat is On
1. Remove battery. Insert battery back
2. Press and hold 'VolumeUp' and 'VolumeDown' keys
3. Insert cable
==== Wait for phone...
Phone found! [ 9 ]
Port Opened
Sync...
InitBoot Done [ 0x81 ] , Ver : SPRD3
Sync...
Sending FDL
[Info] : If SW freeze here more, than 15 seconds - remove cable
FDL Ready!
Boot Ver : SC7731 Crev eMMC Loader v2.0
Sending FLASH FDL
FLASH FDL Ready!
Boot Ok!
FlashMode Set : Ok!
Checking Structure ...
Detected eMMC Flash , Structure detect Ok!
eMMC phone detected! Will use 'Safe Format' mode!
Mount : /data
Size : 0x00000001415F7000
State : 0x0001
Mount : /cache
Size : 0x0000000009600000
State : 0x0001
Prepare Ok! Format Ok!
Don't touch phone, until it fully bootup to "Welcome Screen"!
Android 5.x/6.x : Reset FRP Lock
Reset Ok!
Done!
Elapsed: 00:00:36
Reconnect Power/Cable!
Note: If you find this post helpful then don't forgot to like, share and comment us.