On this post, we are going to share how to boot and Flash Benco Y10 Smartphone. It is based on Spreadtrum Unisoc SC7731e CPU with Android 9 Go Edition. Here we use Infinity CM2 new version Tool i.e. CM2 SP2 V2.14.
👉Step by Step Guides:
- Open CM2 SP2 Tool (use latest version),
- Click on Platform Tab,
- Under CPU [Platform] select SC7731E_BASE,
- Choose Model [Type]: SC7731E_emmc_1GB_RS,
- Click on Identify Device options,
- Power Off your Benco Y10 phone,
- Press Volume Up + Down and Insert USB cable,
- Wait until, Boot Done after that remove USB cable,
- If you get Boot Error then change Model type and retry,
- Now, Go to Flasher Tab,
- On blank area right click and load Firmware,
- Tick on Update PMT and Re-Sparse options,
- Before Flash we recommend you to take Backup of NVM,
- Click on Flash button,
- Power Off your phone,
- Press Volume Up + Down key and insert USB cable,
- Remember that we need to press Boot key on SPD based phones to detect,
- Make sure that you have already Installed SPD Unisoc COM port drivers,
- Wait, few moments until you see Flashing Finished message.
- If you face flash error problem then Tick on Format Flash options then try,
- Format Flash options destroy IMEI/ Serial No. so we recommend all to take backup of NVM,
- If you have backup/ read NVM then you can restore your device Identification,
- After Flash power ON your phone,
- First boot may take several minutes,
- After Welcome Screen appear Setup your phone to get Menu,
- If your Phone have FRP Lock then you can remove it from Service Tab,
- That's all ! Enjoy.
By this way you can boot and flash your Lava Benco Y10 phones. We try our best to help you in repairing fields. All solutions we provide here is tested before posting but, you have to perform this task with your own risk. If you found this post helpful then feel free to share it with your friends.