On this post, we are going to show how to Boot, Format, remove FRP and fix DL image fail on Huawei Y3II (LUA- U22) Phones. It is based on Mediatek (MT6735M -4G MT6582M- 3G) CPU with Android 5.1, EMUI 3.1. Here we use Infinity CM2 new version Tool i.e. CM2 MT2.
👉Step by Step Guides:
- Open CM2 MT2 Tool (use latest version),
- On Plaform/ Main Tab select Huawei ,
- Now Select Y3- II options,
- On right side you can find Global Settings,
- Make sure here you Untick on Meta & Local sSLA options,
- Go to Service Tab (down side 4th tab),
- On Format FS/ Reset Settings select FRP options,
- Now, click on Reset Settings/ Format FS,
- Power off your phone and get ready to press boot key,
- Press Volume up + Volume down key at same time and connect USB cable to your PC,
- Make sure that you have install new version of Mediatek Preloader driver on your PC,
- wait until you see a message i.e. Format OK: RESET PROTECTION,
- Power ON your phone,
- First boot may take few minutes, be patient,
- If you see DL image Fail on your Phone Screen follow below Steps,
- On Service Tab find Misc Section,
- Power off your Y3ii phone,
- Click on FIX DL options,
- Press Boot key and wait until process Completed,
- Power ON your phone and Complete Setup,
- That's all ! Your Phone is ready to use.
By this way you can remove FRP and Fix DL Image Fail on your Huawei (Y3II) phones. We try our best to help you in repairing fields. All solutions we provide here is tested before posting but, you have to perform this task with your own risk. If you found this post helpful then feel free to share it with your friends.